Starter Kit for Battery Sensor & Edge Compute - Singapore
$350.90

This product is approved for for use in Singapore. Now available for shipping.

This starter kit contains a  Milli Developer Kit v1.0 - Singapore  and an IoT Edge Router Kit HW2 - Australia & Singapore with WAN mode for for communication with the network and data backaul.

Itron’s Milli 5 is a cost-effective, energy-efficient sub-GHz wireless communications device. The Milli 5 is optimized for a wide range of 802.15.4g network applications and is the first in the family of such devices. It may be integrated with battery-powered devices such as water meters, photocells, and logistics pallet tracking devices. It comes equipped with on-board firmware that supports communications in an IPv6 wireless mesh network. This Milli 5 based developer kit uses an Arduino shield for easy integration with any compatible Arduino R3 boards. Firmware currently supports CoAP over UART communication with integrated devices.

Itron's IoT Edge Router is a hardware device that enables customers to securely connect a variety of devices—including those that require legacy-protocol support— across a common RF mesh network infrastructure using proven open standards and interfaces and networking protocol support. Support includes a secure and standards-based architecture for both IPv4 and IPv6 communications with Linux-based network-edge computing capability. 

The IoT Edge Router WAN mode provides data backhaul to back office software for other connected devices including the Milli Dev Kit and devices with integrated Itron NICs such as the Milli NIC.

 

Included in Dev Kit:

  • Milli 5 NIC Arduino shield board
  • Antenna
  • USB/TTL smart cable
  • Quick Start Guide
  • IoT Edge Router HW1 - Australia & Sngapore
  • Generic Wireless HW1/HW2 Accessory Kit

 

You will need an Arduino processor board to make use of this kit.  We have verified the Arduino M0, Arduino M0 Pro,  and Arduino Due boards (see http://www.arduino.org/products/boards) are compatible for you to purchase separately. Other boards may work but there is no guarantee. 

 

We also recommend you purchase any sensors you wish to integrate along with a breadboard and connecting wire.

 

The kit is comprised of the following catalog items:

  1. Milli Developer Kit v1.0 - Singapore
  2. IoT Edge Router Kit HW2 - Australia & Singapore

 

The following countries are supported.

 NAN1 BAND 
 CC* 
 HW 
 FREQUENCY BAND 
 POWER
 COUNTRIES 
 SGP
702
2
 920-925 MHz
 350 mW (erp) 
 SGP

* The CC is the "country code" that will be used to configure the device for the proper country frequency band.

260-010221 / 385-002200 / 201-450022