Milli Developer Kit v1.0 with Arduino
$99.95

This product is approved for for use in USA,Canada, Jamaica and Australia. Now available for shipping.

Milli Arduino shield with Arduino M0 Pro or Adafruit Metro M0 Express - requires at least one IoT Edge Router HW1 - USA, Canada & Jamaica or IoT Edge Router HW2 - Australia & Singapore (with WAN mode) device for communication  with the network. MiniAPs  have been discontinued.

TheItron Networked Solutions’ Milli 5 is a cost-effective, energy-efficient sub-GHz wireless communications device. The Milli 5 is optimized for a wide range of 802.15.4g network applications and is the first in the family of such devices. It may be integrated with battery-powered devices such as water meters, photocells, and logistics pallet tracking devices. It comes equipped with on-board firmware that supports communications in an IPv6 wireless mesh network. This Milli 5 based developer kit uses an Arduino shield for easy integration with any compatible Arduino R3 boards. Firmware currently supports CoAP over UART communication with integrated devices.

 

Included in Dev Kit:

  • Milli 5 NIC Arduino shield board
  • Arduino M0 Pro or Adafruit Metro M0 Express
  • Antenna
  • USB/TTL smart cable
  • Micro USB Cable
  • Quick Start Guide

 

We also recommend you purchase any sensors you wish to integrate along with a breadboard and connecting wire.

 

The following countries are supported.

 NAN1 BAND   CC*   HW   FREQUENCY BAND   POWER  COUNTRIES
 AUS 36 2  915-928 MHz 350 mW (eirp) 

 AUS

 USA 840 1  902-928 MHz 350 mW (eirp) 

 USA, CAN, JAM 

* The CC is the "country code" that will be used to configure the device for the proper country frequency band.

 

*Note: Requires at least one IoT Edge Router HW1 - USA, Canada & Jamaica or IoT Edge Router HW2 - Australia & Singapore (with WAN mode) device for communication  with the network.

260-010202